Tuesday, October 28, 2014

Some Advantages of New Sails

Besides looking nice, new sails have some big advantages.  






Here’s a photo of Snickerdoodle with both sails looking pretty old.  Notice the stretch wrinkles on both sails.  There was no way that I could tighten lines to eliminate the wrinkles.  The both sails had stretched far enough that making them smooth again was impossible.



This year I bought two new jib sails (a 135% and a 150%).  These match up really well with my three-year-old mainsail.  Here are a couple photos with the “new” mainsail and the NEW 135%.  See you smooth the sails look.



When your sails get blown out like in the earlier photo, they only work ok for downwind legs.  When you try to sail upwind close hauled, the wrinkles disturb air flowing over the sails and the sails loose lift.  To help correct this, most skippers fall off to a close reach.  This works – but the boat ends up sailing farther than in should.  When the wind pipes up, the old sails cannot be flattened appropriately and the boat heels more than you want.  The passengers are nervous.  The boat heels over and wind spills out of the sails… OR you sheet out in order to spill wind and decrease the heeling.  Either way, now the boat is sailing slowly in a sideways direction because the keel no longer grips as efficiently.
When all this is going on, the pressure on the tiller is often times immense.  You might have to hold on to the tiller with both hands in order to control the boat.  Even with both hands though, the boat still has too much weather helm and rounds up uncontrollably. 




Saturday, October 11, 2014

Winterizing Your Boat Check List



Winterize Your Sailboat Check List



1996 Photo
All of us who live in the inland Pacific Northwest must be aware of potential dangers that freezing weather may bring to our sailboats and prevent potential damage by winterizing our boats.  Whether your boat spends the winter on a trailer or in the water, you must winterize.  There are too many horror stories about boats sinking while in the slip …… or sinking when first launched in the spring.  Sinking is nearly the worst thing that can happen on your boat.
Water (freezing water) will do considerable damage. Freezing water can break thru hull valves, raw water strainers, engine blocks, fresh water systems, marine heads and porta-potties, and anything else that has water in it during the winter.
So, here is a typical check list of things to do aboard your boat to make sure that she’s ready for winter.
The first thing to do is to check the owner’s manuals for equipment aboard your boat.  Are there specific recommendations for winter conditions?
Next prepare a written checklist so that you will cover all the “bases”……  Here are some of the “bases”…
Clean out the boat.
Remove all electronic equipment and store it in a warm dry place.  Check your owner’s manual for info on how to store this gear.
Remove all sails, lines, anchors, fenders, pfd’s, bunk cushions, flares, fire extinguishers, carpets, etc.  Check and repair these over the winter.
Empty all lockers, especially food lockers.  Take all loose gear off the boat.
Securely prop open all locker doors, access hatches, bilge access and anything else that will improve air circulation.
Open and clean the ice box and/or refrigerator.
Drain all the water from the fresh water system.
For a fairly simple system, drain all the hoses and drain and clean the tanks.  Leave everything empty.
For more complicated systems with heaters and electric pumps you’ll need to empty all water, header and heater tanks, making sure that no water remains in the tanks below the outlet level.  Clean the tanks and wipe internally with a chlorine solution.
Make sure you disconnect the electrical supply to the heater tank before you drain it.
Drain all the water from the hoses and pumps – you may need to disconnect hoses at both ends to do this.
Reconnect the hoses ad bypass the water tank.  Pump pink, eco-friendly anti-freeze into the hoses and pumps to protect them from any residual water.
Check shower sump for water.  Sponge dry if necessary.
Drain and winterize the head.
Pump out the holding tank.  Flush the head with fresh water several times while emptying the holding tank.
Close the head intake seacock and romove the hose.  Sit the hose in a bucket of 50-50 eco-friendly (pink) anti-freeze and water.
Pump the head until all water in the bowl and hoses has been replaced by anti-freeze.  Replace the hose on the seacock.
Don’t open the seacock until next spring.
Winterize the batteries.
Remove the batteries to a warm dry place.  Keep them off the ground.
Fully charge the batteries before storage and recharge every month in storage.
Don’t leave the batteries connected to the charger.
Winterize your diesel inboard engine.
Fuel system
Add stabilizer/biocide to your fuel tank and fill the tank.  Read the instructions on the stabilizer container.
Change all fuel filters and drain the water separator.
Run the engine for 15 minutes to get stabilized fuel into all lines and injectors.
If already on the hard, run a water hose to the raw water intake to get anti-freeze into the engine.
The oil system
Drain the oil while the engine is still hot from the fuel circulation above.
Change the oil filters
Fill engine with clean oil
Drain the oil in the transmission if separate from the engine.  Refill with clean oil
The fresh water cooling system
Drain the fresh water cooling and heat exchanger system and replace the coolant with 50-50 pink anti-freeze
Winterize the raw water side as detailed below
Flush the raw water cooling system
Close the raw water seacock
Disconnect the hose on the outlet side of the raw water pump
Place the end of this hose into a large bucket.  Have a second bucket handy.
On the exhaust riser or muffler, disconnect the cooling water hose
Connect this hose to a water supply and back flush the raw water system
Collect the flushing water in the buckets and dispose of properly
Reconnect both hoses.
Replace the raw water with anti-freeze
Close the raw water seacock
Disconnect the hose from the seacock
Place the hose in a bucket of 50-50 mixture of pink anti-freeze and water
Start the engine and run it until pink anti-freeze is discharged from the exhaust
Turn off the engine and reconnect the hose to the seacock
Do not open the raw water seacock until next spring
Drain the anti-freeze from the muffler if you have a drain plug.  Reinstall this plug immediately
Remove the raw water impeller and store.  Tag the engine so you remember the impeller is not installed next spring
If you are already on the hard you can leave the seacock open and run a hose from the raw water intake to a bucket of anti-freeze mixture and proceed as above
Close the seacock afterwards
Sundry work
Spray fogging oil into the intake manifold and turn the engine over by hand.  Don’t use the starter motor.
Spray the inside of the ignition switch with WD-40 or CRC
Cover the engine with a waterproof cover to protect from any leaks above the engine (deck, cockpit, etc.)
Seal all air intakes, breather pipes, tank vents ad exhaust outlet with duct tape or plastic seals.
Winterize your gasoline inboard engine.
Follow the steps above regarding; The oil system, The fresh water cooling system, Flush the raw water cooling system, and Replace the raw water with anti-freeze
The fuel system
Start the engine and shut off the fuel supply
Spray fogging oil into the air intake while the engine is running
Run engine until it stops
Drain the gasoline tank and all gasoline lines.  Ethanol in modern fuel absorbs moisture, separates, and damages gaskets and rubber fittings.
Put the fuel into your car’s fuel tank
Sundry work
Spray the inside of the ignition switch with WD-40 or CRC
Cover the engine with a waterproof cover to protect for any leaks from above
Seal all air intakes, breather pipes, tank vents, and exhaust outlet with duct tape or plastic seals
Inspect fuel tanks, lines, pump and filters for leaks
Winterize your gasoline outboard engine.
Start the engine
Disconnect the fuel line at the engine and spray fogging oil into the carburetor air intake
Run the engine until it stops
Change the lower unit gear grease
Drain the gasoline tank and all gasoline lines.  Ethanol in modern fuel absorbs moisture, separates, and damages gaskets and rubber fittings.
Put the gasoline into your car’s fuel tank
Clean and inspect your boat
Internal clean
Remove all loose gear from the boat
Wash down all surfaces to remove any dirt or grease that will allow mold to grow
Scrub the ice box and/or refrigerator with a mild bleach solution
Clean out the interior lockers
Clean the bilge.  Scrub with soap and hot water.  Add pink anti-freeze to the bilge to stop any remaining water from freezing
External clean
Scrub or pressure wash the hull and deck
Clean hardware, mast and rigging to remove salt, dirt, and grime
Touch up any damaged varnish or paintwork
Lightly wax all fiberglass surfaces to protect over the winter
Inspect the hull
Inspect the hull for cracks, blisters or any stress cracks.  Repair as necessary
Inspect the deck for cracks.  Check for delamination at cracks and repair if required.
Install backing plates to hardware or stanchions showing signs of stress cracking before repairing
Inspect lifelines for signs of corrosion.  Replace if necessary
Inspect sundry systems
Inspect propane lines for damage.  Make sure they are well supported.
Close propane bottle and light the stove.  Allow the stove to go out.  Close off the supply at the stove.
Remove propane bottles from the boat  Seal the end of the propane line
Inspect all fuel supply lines for softness, brittleness or cracking
Inspect fuel fill line and fuel vents.  Check all joints for leaks.
Ensure all lines are well supported with clips or straps
Inspect and service all winches, mainsheet system, turning blocks and rope clutches
Lubricate the roller furling system if fitted
Inspect and service all seacocks
Inspect all hoses and hose clamps.  All hoses should be double clamped.  Replace hoses and/or clamps as necessary
Inspect all electrical connections.  Clean and reconnect if required.
Since I have shore power
Connect the 110 VAC dehumidifier
Connect the 40 Watt heat strip
Fill the two Dry-Z-Air dehumidifiers and place one in the galley and one in the head
No doubt that this is an incomplete list……  add to or delete from this list for your own boat.  Remember that freezing water is the most dangerous winter hazard to your boat!!!